Pembuatan Prototype Sistem Kompressor Udara Start Pada Kapal

Main Article Content

MARUF NUR AZIZ Amad Narto Mohammad Sapta Heriyawan

Abstract

In this era, there are lot of learning methods in maritime education especially on board. One of the method using machinery simulation on board. So the author decided took the subject to make a prototype one of the machinery on board, it's air compressor system start on the ship. The purpose of this research to know how it work and the system, as well as the benefits of this air compressor simulation system start on board. The method used is Research and Development, it's used to develop a new product or improve an existing product included hardware or software. This starting air compressor simulation system on board is utilized by two electronic modules where the module type is timmer delay relay1 channel module, and a 2-channel timmer delay relay module. Both of the modules are programmed directly with the buttons on the module. The compressor system by filling the air on the tube until the pressure is sufficient, then the compressed air on the tube will be used to start the main engine in the form of a simulation of a piston cylinder of a 4 stroke engine. This system can run due to automation control of electronic modules.


Keyword : Prototype, compressor, timmer delay relay

Downloads

Download data is not yet available.

Article Details

Section
Articles

References

Annisah, S. (2017). Alat peraga pembelajaran matematika. Tarbawiyah: Jurnal Ilmiah Pendidikan, 11(01), 1–15.
Arsyad, A. (2013). Media pembelajaran edisi revisi. Jakarta: Rajawali Pers, 24, 4.
Astriawati, N. (2020). Development of interactive media based on videoscribe with realistic mathematics education approach to navigation. Math Didactic: Jurnal Pendidikan Matematika, 6(3), 321–333.
Borg dan Gall. (2015). Pengenalan Metodologi Penelitian danpengembangan. danpengembanganRineka Cipta.
Fitrah, M. (2018). Metodologi penelitian: penelitian kualitatif, tindakan kelas & studi kasus. CV Jejak (Jejak Publisher).
O’Brien, J. A. and G. M. M. (2010). Management System Information. Mc-Graw Hills.
Prasetyo, D. (2018). Evaluasi Hasil Belajar Menggambar Dan Mendesain Mesin Antara Taruna Dari Input Sma Dan Input Smk Dengan Metode Kelompok-Kelompok Kecil Jurusan Tehnika Di Pip Semarang. Dinamika Bahari, 9(1), 2189–2196.
Saifuddin, M. S. I., & Wekke, I. S. (2018). Strategi dan Teknik Penulisan Skripsi. Deepublish.
Tahara, H., & Sularso, P. (2006). Kompresor: Pemilihan, Pemakaian, dan Pemeliharaan. Jakarta: PT. Pradnya Paramita.
Timotius, K. H. (2017). Pengantar Metodologi Penelitian: Pendekatan Manajemen Pengetahuan untuk Perkembangan Pengetahuan. Penerbit Andi.